Get to Know What You Must Do When You Hang Wall Cabinets
You know very well that the kitchen cabinets are available in so many retail locations and you must not be afraid to install them on your own. You will surely find this to be an excellent do-it-yourself project. With such tips, then you can certainly save time and avoid the expensive mistakes from taking place during the installation process. Once you have proven this to work, then you will be able to install other wall cabinets in the future.
The wall cabinet tools that you will need are 4-in-1 screwdriver, 4 foot level, 2 foot level, 2 cordless drills, clamps, hole saw kit, drill bit set, level, jigsaw, pry bar, the miter saw and the stud finder. The first thing to be done is to mark the wall for you to get the layout. This can avoid surprises later on during your installation of the cabinet on the wall. You must search for the highest point in the floor and draw a line 34 1/2″ up and mark this as the top of the base cabinet. Measure 19 1/2 inches from the line and draw another line and this will be for the bottom of the wall cabinet. You need to measure and mark the layout for every wall cabinet on your wall. You have to draw a vertical line for the installation of the first cabinet. Mark the stud locations on your wall below where the bottom of the cabinet will hang.
On the installation process, you must remove the cabinet shelves and doors first. By doing so, you won’t have to worry of the weight of the cabinet since it is lighter. Also, it will be less awkward for you to hang.
You must check the wall by holding that 4 foot level against it so that you can assess if there are big bumps or dips that you need to be concerned of. Know that you will find it much easier when you don’t lean over the base cabinets as you hang it. You have to screw the ledger board on the mark for the bottom of the cabinets. Make sure that you screw this in 2 studs or three. You may rest the cabinets on the ledger board so that you can ensure a straight alignment and this will hold the cabinet in place as you screw it to the wall.
Work on screwing all the other things that you should be screwing in place. For the outer edges of the cabinet, it is best that you use four screws. If the cabinet is smaller, then you can just have a couple of screws inside.
You can then put back the doors of the cabinet and find out if there is no problem in the operation. Be watchful as you redrive the screws for the cabinet door hinges. The screws are often made from soft metal making the head to easily strip and the shat easy to snap off.