The use of wooden floors need not be confined only to homes it is also a good alternative to carpeting and other types of flooring for offices, as it gives a very good impression to visitors. The only drawback is that with repeated use, these floors have the tendency to become worn out with scratches, scuffs, and stains. The only way to bring this type of flooring back to its original condition is to use the services of a very good wood floor restorer.
Choice of Restoration
There is no doubt that doing a full wood floor restoration is certain to extend the life of the wooden floor in question it does not matter what type of wood has been used. In most cases, the restorer will start the work with a full assessment of the condition of the floor and the areas of extreme damage before starting the first phase of restoration work, which is sanding. There may be areas that may need to be removed and replaced with the closest approximation of the existing wood to maintain continuity. The kind of flooring also plays a very important part before starting work, if the wooden floor has parquet flooring or the usual tongue and groove timber boards.
Different Time Scales
Depending upon the type of flooring, the approach to wood floor repair will be different, though there will be some parts which will be common to all types of wooden flooring. Even the time involved for sanding the floor will depend on the type of wood, as hard woods like oak, beech, ash, and mahogany take a much longer time to sand than soft woods like pine. Once this process has been completed, the smoothing work starts to ensure that there are no rough patches before the application of the protective wax, stains, or oil. Again, depending on the type of hardwood, the finish will be specified after the sanding and smoothing work is completed. This process brings out the beauty of both tongue and groove wooden boards as well as parquet floors.
Of course, in all types of flooring, the final finish will depend on the quality of the wood floor sanding that has been done before starting the staining and polishing work. Use of the latest mechanical sanders helps in the removal of the existing protective floor layer, which could be oil, wax or varnish this process will leave the old floor without any blemishes and the surface clean, flat, and smooth. It is only after the experts agree that the floor has been sanded to his satisfaction that the next step can be started, i.e. staining the floor with natural wax, oil, lacquer or varnish.